Publications

"Narrow Bandwidth Top-Emitting OLEDs Designed for Rhodamine 6G Excitation in Biological Sensing Applications", Matthias Jahnel, Beatrice Beyer, Michael Thomschke, Karsten Fehse, Felix Krujatz and Karl Leo, Electronics 2015/4, pp. 982-994

 

[ More ]

Abstract: Organic light emitting diodes (OLED) are promising candidates offering in optical sensor applications to detect different gas compositions and excitable optical marker groups in chemical and biological processes. They enable attractive solutions for monitoring the gas phase composition of e.g., dissolved molecular oxygen (O2) species in bio reactors or excitation of fluorescent markers. In this work, we investigate different OLED devices for biomedical applications to excite the fluorescent dye rhodamine 6G (R6G). The OLED devices are built in top emission geometry comprising a distributed Bragg reflector (DBR) acting as optical mirror. The OLED is optimized to provide a very narrow emission characteristic to excite the R6G at 530 nm wavelength and enabling the possibility to minimize the optical crosstalk between the OLED electroluminescence and the fluorescence of R6G. The DBR includes a thin film encapsulation and enables the narrowing of the spectral emission band depending on the number of DBR pairs. The comparison between optical simulation data and experimental results exhibits good agreement and proves process stability.

Keywords: OLED; sensoric; DBR; biochemical sensor; Rhadamin6G; narrow emission; lab on chip


"A novel Micropump Driver used in environmental sensor applications", Bernadette Kinzel, Detlef Bonfert, Florian Lippert, Frank Vanselov, Erkan Isa, Doris Schmitt-Landsiedel, Linus Maurer, IEEE SENSORS 2016

 

[ More ]

Abstract: The reaction times of environmental sensor units are potentially improved by the use of micropumps. Those micropumps require miniaturized driver electronics which generate dual-polarity high voltage pulses optimized to drive light, capacitive load piezoelectric micropumps. This paper presents a novel micropump driver consisting of a DC/DC converter circuit that is based on a combination of a boost converter and a charge pump. This combination generates asymmetric high voltages on two individual synchronous output nodes from a 5-V supply. Through reduction in the number of coils this method supports the overall system shrinking and allows a high level of chip integration. Compared to state-of-the-art miniaturized drivers, the presented topology allows single-ended and differential micropump driving at higher voltage levels (-100 V/+150 V). By connecting the micropump differential to the converter output, the maximum voltage can be increased to 250 V for capacitive micropump loads of up to 200 nF. The converter topology was validated by measurement. The presented novel, miniaturized micropump driver topology allows micropump integration into mobile devices for new fields of sensor applications with rapid reaction times.


Deliverables

Upcoming:

D1.2 Draft of line capability report including key performance indicators
due date: April 2017 – M24

D8.3 Intermediate business plan and exploitation report
due date: February 2017 – M22

D6.2 Public IT component and architecture specification
due date: December 2016 – M20

Public:

D7.1 System Specification and system related pilot line requirements
due date: April 2016 – M12

D9.3 Risk Assessment Plan
due date: February 2016 – M10

D8.2 Initial report and updates on dissemination, exploitation and standardisation activities
due date: February 2016 – M10

D1.1 Business Process Model (BPM) and Specification Sheet
due date: October 2015 – M06

D8.1 Data Management Plan (DMP)
due date: October 2015 – M06